I have a nano premium and I have updated all files and installed s1.iks66.tv as per Rob318us rechecked several times and rebooted on back as well as Fn1 key but still get "scramble" any suggestions would be appreciated!
thanks
kermitii
I have a nano premium and I have updated all files and installed s1.iks66.tv as per Rob318us rechecked several times and rebooted on back as well as Fn1 key but still get "scramble" any suggestions would be appreciated!
thanks
kermitii
Is the receiver communicating with the router?
Check in the Network menu for the IP to populate. While in that menu, disconnect the Ethernet cable from the back of the receiver and then change the menu and go back to the IP menu and it should show all zeros. Then reconnect the ethernet. The IPs should repopulate.
Then exit the menu to a tv channel.... and does it show connect 1 or 2 at the bottom of the screen?
I followed your directions and all went as per them except that at the bottom of the sreeen it says Connection: but no 1 or 2!
thanks
kermitii
we need a bit more ifo..post your settings maybe we can help you ther bud
By settings do you mean Dream 1, NewCam s1.iks66.tv port 50066 DESkey 1234123412341234123412341234 route 25etc and have checked routes are active and running! If you mean some other settings I will be happy to provide them!
thanks
kermitii
yes the other settings like antenna settings.and what sat are you locked on..thank you
119 and110 channel 200, 121 etc. very strong signal! When I go directly from my modem to SAT I do not get the IP to populate but it does through my router Linskys!
thanks
kermitii
on your antenna settings you have a like
antenna 119
lnb type
diseqc
etc,etc,post all than info please
ohhh one more thing make sure you receiver is plugged to your router
OK will try
lnb standard 10750 for 119
lnb standard 11250 for 110
diseqc 110 3, 119 4
yes plugged into router and populate IP after Apply repopulates!
thanks
kermitii
what type of lnb are you using DP,DPP,OR WHICH ONE,,are you using linear lnb?