CP/ Relentless

The Coolview X3 HD is a lot like a Dreamlink T5 in some ways.
The 8psk is the same install as the Dreamlink T5.

Take the DL100 and line up the legs on it to match the 2 pegs on the board at each end.
Press in lightly till it's in.
Take the rubber silicone heat sink and place it on the black strip on the top of the DL100.
Now put the lid back on the box making sure the rubber/silicone heat sink is in place.
This helps to keep the unit cool expelling hot air out the top of the box.
See the pic you will see the rubber/silicone heat sink on top of the new DL100.

First make sure you have formatted your usb stick in your computer.

Place the factory file on your usb stick located here...


Then place the latest bin file on your usb stick here...


When you put the files on the usb stick and place it in the Coolview X3 HD a Usb Explorer window will pop up and show you the files on the stick.

First place the factory file on the Coolview X3 HD, Then do a factory reset of the box in menu.(Located on Configuration then over to System Recovery click ok you will see factory reset.) Password is 0000.

Again the Usb Exporer window will come up. Then select the latest bin file and place on the box....do a factory reset in menu again.(Located on Configuration then over to System Recovery click ok you will see factory reset.) Password is 0000.

Then go in Menu to Installation scroll over and down to Option and select Renumbering by SID to ON and make sure Auto CH/TP Update is selected to ON.Also make sure short ch name is selected.Mode should be Network.

Then while still in Installation select Dish Settings and set up your sats and scan.

When done exit and save.

Next go to Configuration...Set your Time and your A/V Output Settings and also UI Settings.

Then to Network Settings and hit the Blue button on remote to set up your servers. A box will appear select password 0000.

You have 10 private server you can put in.

To place your servers in take time and make sure all your ps settings are right.Here how to do...

Name or ip..after done push exit

Ports...when done push arrow down on remote directional pad

Id ...after your done press exit

Password...after done press exit

Des Key..after done press exit

If all is right hit red button to save.

Connect....press ok and see if it connects, if it says not connected hit it again and see if it does. If not you havnt put in the ps setting right.

Press exit ...you will be back to server setup...make sure you see your ps is on not off.

Press exit again you will be back to Network Settings leave it sit three you will see a box pop up and it will tell you which servers are connected.Will say Network is Connected (1)(2) if you have 2 activated. Exit out if connected.

Next you can go to Channel List and do your Parental Control if need to.Set favorites or edit your channels is you wish to.

Next is Utilities thats where you can see System Information on your box. Mp3 Player is there...Image Viewer Data transfer if you want to save Ch list or put a file on and also the PVR Menu

Which i think you all know what to do in those places.

That pretty much sums it up to get it going on the servers.

Enjoy your box.