Hello and welcome to our community! Is this your first visit?
Register
Results 1 to 1 of 1
  1. #1
    IKS66 Junior Member
    Join Date
    Aug 2014
    Posts
    8

    Jynxbox V2 and up dead free Repairs

    for those of you with a dead Receiver clone or not clone. U7 MEMORY CHIP is the same no matter the version. Follow the information from ENGEL RS4800 but you must disconnect U7 MEMORY CHIP Terminal 3 to eliminate the signal from the main Board. I use a N/O mini push bottom from RadioShack. I Repair my two babys in 40 min. Your Receiver runs cooler if you turn off the NLB power. You only need that on if you use a motor. Mount the push bottom on back of the unit or cover. And The U7 MEMORY CHIP Terminal 3 is WP Only need power signal for seconds is the Factory default
    Last edited by Ramon1999; 09-13-2015 at 08:54 PM.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •