Hello and welcome to our community! Is this your first visit?
Register
Results 1 to 5 of 5
  1. #1
    IKS66 Junior Member
    Join Date
    Feb 2015
    Posts
    8

    TP exist Try again!

    We are getting some channels on both 110 & 119, but signal is not where it should be and are getting an error message on some "bad or no signal".
    On my T5 box, in PID, when I change the symbol rate to 21500 and enter I get a message that "TP exist Try again" after changing to turbo the signal improves, but I am unable to save or scan without the "TP exist Try again" message popping up.
    Know that I am missing something that will be obvious to most.

  2. #2
    Super Moderator Sammy's Avatar
    Join Date
    Feb 2013
    Posts
    2,885
    When you get that message exit out and go to the next tp. JUST DON'T DELETE THE FIRST TP. Do the delete until all are gone but the first one(yellow button) Scan id installation not pid or manual.

  3. #3
    IKS66 Junior Member
    Join Date
    Feb 2015
    Posts
    8
    Thanks for your help.

  4. #4
    Banned
    Join Date
    Jan 2015
    Posts
    18
    I'm having the same problem.. TP already exists.. I've also noticed I have the same TP 1 @20.000 and the other 21.500 turbo.. The The tp#s don't match up to my receiver.. Any thoughts how to fix this issue?? Not sure if I should start deleting tps. I don't wanna screw **** up..

  5. #5
    Super Moderator Sammy's Avatar
    Join Date
    Feb 2013
    Posts
    2,885
    Reread post #2.


 

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •