Set-Up Guide for the SlimSat 5000

- Download / Extract Bin and load to a USB Stick
- Load Bin to the box via USB Stick.
- Wait for a prompt "Main S/W is found. Would you like to update" click "ok" to update.
- On "Downloading. Do you want to proceed?" click "Yes"
*** if there is no prompt
- Go to menu =>USB Transfer => Download from USB => select the correct bin => click "ok"
- Wait for the "keep your USB connected until transfer is done" is done. The box will reboot.
- Do a Factory Default

- Select Language
- Select Time Zone
- Select "No" on Auto search
- Select satellite => LNB Type => LNB Frequency => DiSEqC and click "ok" on start scan.

** click "Exit" for multiple Satellites. From main menu, go to the Dish.
- Do Antenna set up for all satellites. The box will give a sound and visual confirmation if the satellite has been locked.
- After all satellite setup, move the cursor to Satellite and click red button to scan.
- Select scan type of your choice
- Check mark all the satellite you want to scan and select Start Scan.

Setting up the Network

- Click Menu => Network Setup (Advanced) => Internet Protocol confirm proper IPs (Network Setting to Auto-Detect) and click Exit
- Click Connection Mode => Select "Newcamd" on Connection Mode and click "ok".
- Select server and enter the information. Can enter up to 9 servers and select "enable" to the desire servers. Click exit and click "Yes" to save
** This screen, either click "red" button to save information or click "green" to load information.
- Click Exit and select "Yes" on Do you want save changes? This will reset STB.