Install the latest firmware.

Do a factory default and hard reboot.

Set up sats and scan - make sure you get free channels like DNFYI 101 for 119 sat.



C/P by Rob318us
Go to menu screen Highlight installation. Then press the right arrow button on the remote.

Highlight Network and press the ok Button on remote then change the type setting to Dream By highlighting and using the left or right direction key on the remote..


Then scroll down and put in the domain in or IP address for the private server as shown below.

Note
You will have to change the input type to Domain in the net application screen.


In server and port, enter the server and port you got with your code. The server MUST be in small letters! Check at the end on how to switch from capital to small and back.


Note: You can run up to 2 servers at the same time by changing the server no. setting to 1 or 2.

Then scroll down to authorization and press ok button on the remote.

Then you will add your ID and Password (both will be your 14-digit access code) and the Des key 6103403445406970987123412134.
For each line you edited after you edited it you will have to hit the exit button on the remote then hit ok button and go to the next line and then exit out of the menu and you then should be connected to the private server.