I'm not sure what dish you are using or your computer speed check all cable connections if even 1 small ground wire is touching the internal cable it will cause problems,
With that said I am scanning both 110 and 119 with a 1000.2 dish turbo at 97%
LNB power ON
LNB type OCS-DP
LNB freq 11.250
22 khz OFF
SWITCH 1.0
Commited 1 for 119 and 2 for 110 respectively, as my dish has a built in Switch.
Legacy Sw OFF
Hopefully this helps, only other thing I can think of is how the code must be written for the bottom line for the coolsat in the CONF file for the RQ.
mine is as follows
Your code for coolsat 6000
To be interred into bottom line of CONF file
First vaiiables.
Change the 0 to a 1 for coolsat
Change the AAAAA to username and password
Change the BBBBBB to ip or site address of server
Change the CCCCCCCCC to des key.
Make sure you have the right number of slashes etc.
card_server_url_0=newcamd://AAAAAAAAAAAAA:[email protected]/CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
When finished entering the code the correct way make sure you hit enter on your keyboard to go to the next line without typing anything it helps the server know it is the end of the code.
Alcu.