C/P

My friend sent me his Jynxbox cause of a bootloop problem.When I switched on the receiver,in the readout you'd see "Boot"..."On"...."STRT".That's all it would do over & over.To fix this problem,you need the HD Loader & a straight through serial cable.Follow instructions for the Loader.You'll also need the factory Firmware.


When you get to Page 2 where it says "Make sure the receiver is on and click the Connect button.",you DO NOT select firmware but you select All Chunk.Once you select "all chuck",down at the bottom of the load you'll see a dropdown arrow.Click the dropdown arrow & select All Files.You need to select "all files" otherwise you won't see the factory firmware.Once this is done,click Next & let the loader do it's thing.It will first read it & then write.If you see an error,don't worry about it,it will retry & finish the process.The receiver will then restart.You'll see "Boot"..."On"..."STRT"..."No CH".now you're good to go.