C/P from Relentless
This is how to install the SK200 8psk into the MegaTVi box.
There is no need to take the top of the box off. I dont suggest it as you may break it if you try to do so.
Now if you do have trouble putting the sk200 in the way I did it you can take the top off the box to watch it goes in.
Just be gentle when you take the top off the box. If the receiver is facing you with display the left side is hard to get off the box. Use kid gloves to remove it you don't want to break the clips that attach the lid to the box.
Also no heat sink required and no fan either. The box is light warm after 10 hours of play.
Here is the back of the box with the tuner port.
megapic1.jpg
Notice there is a sticker over the opening to place the tuner port in. Take the tape off.
megapic2.jpg
You will see a metal part over the hole which i refer it to as a dummy door. Have a good look on how its put in because you have to put it in the exact same way as the dummy door.
megapic3.jpg
Now remove the dummy door.
megapic4.jpg
Notice that the tuner port has the same dummy door attached to it.
megapic5.jpg
Its easy to place the SK200 in just line it up and press down gently.
megapic6.jpg
megapic7.jpg
Make sure the pins are lined up and going through the holes on the 8psk.
You will hear a little snap sound when you have it in completely.
megapic8.jpg
Now lets look in the hole in the back of the box. You will see where the tuner port plugs into the main board.
megapic9.jpg
Now take the tuner port and line up the legs on it.
megapic10.jpg