Limesat HD Set Up Instructions
Important: How to install module and the beta 2.01 file.

1) Before plugging in the power cord, open STB & very carefully exchange the module.
Do not try to remove the white strip on the chip, it's a ceramic heat sink, not 2-way tape.

2) Write the 2.01 file.

3) Do all your settings, time etc.

4) Go to installation menu & select manual scan.

5) Hi-lite each of your sats & select turbo 8psk & save changes.

6) Go to satellite search menu & put in your settings & scan. Note: If you notice that you are missing any
transponders, you can go back to manual scan, choose the missing TP on whatever Sat & scan it.

7) Go to server settings, select each one & put in your settings.

8) After each setting just exit. When all are done, save.

9) Go back to settings window & scroll right to open position.

10) Select re-activate server.

11) Repeat for each setting. Beware, if you have to select any symbols, like the #, it won't show until you exit.

12) It will say "network connect, 0 servers". This a bug, when you exit & go to a channel, it will be there.

13) If you have more than 1 server, you can enter them all. It is not necessary to disable any of them.
When you select a channel the box will cycle through all your servers to find which one has the channel open.
Bev channels use a 1 prefix for the regular channels & a 2 prefix for the HDs.

I think I've covered everything,

c/p