Limesat HD Set Up Instructions
Important: How to install module and the beta 2.01 file.
1) Before plugging in the power cord, open STB & very carefully exchange the module.
Do not try to remove the white strip on the chip, it's a ceramic heat sink, not 2-way tape.
2) Write the 2.01 file.
3) Do all your settings, time etc.
4) Go to installation menu & select manual scan.
5) Hi-lite each of your sats & select turbo 8psk & save changes.
6) Go to satellite search menu & put in your settings & scan. Note: If you notice that you are missing any
transponders, you can go back to manual scan, choose the missing TP on whatever Sat & scan it.
7) Go to server settings, select each one & put in your settings.
8) After each setting just exit. When all are done, save.
9) Go back to settings window & scroll right to open position.
10) Select re-activate server.
11) Repeat for each setting. Beware, if you have to select any symbols, like the #, it won't show until you exit.
12) It will say "network connect, 0 servers". This a bug, when you exit & go to a channel, it will be there.
13) If you have more than 1 server, you can enter them all. It is not necessary to disable any of them.
When you select a channel the box will cycle through all your servers to find which one has the channel open.
Bev channels use a 1 prefix for the regular channels & a 2 prefix for the HDs.
I think I've covered everything,
c/p