===============================
XX-Client Release v2.4
===============================
Protocols supported:
Viewsat
CNX
Coolsat
Captiveworks
Notes:
[caid.ini]
If you need to use CaID remapping simply place a line for each CaID that needs to be remapped.
Like so -
1841=1815
1802=1816
[xx-client.ini]
----------------------------------------------------------------------
Setting: serial_port
Description:
Serial port receiver is connected to.
----------------------------------------------------------------------
Setting: serial_speed
Description:
Serial port speed. I found a baud rate of 19200 works for receivers that use to use a Weather Forecaster and variants (CNX). While a baud rate of 115200 works for all other receivers, including the new Viewsat firmwares that use the Coolsat protocol.
----------------------------------------------------------------------
Setting: server_timeout
Description:
Control word retrieval timeout in seconds.
----------------------------------------------------------------------
Setting: server_retries
Description:
Number of attempts before connecting to a new server. Setting to '0' will make the client try the next server after first failure.
----------------------------------------------------------------------
Setting: receiver_protocol
Description:
Receiver protocol to use.
1 = Viewsat/X-Factor
2 = CNX
3 = SSSP Viewsat/SSSP Pansat/Coolsat
4 = Captiveworks
----------------------------------------------------------------------
Setting: ignore_caid
Description:
If set to 1, CaID reported by the receiver will be ignored and ECM will be sent to server even if there is a CaID mismatch. If you are using a single provider you should set this to 1. CaID matching is used to make provider switching faster.
----------------------------------------------------------------------
Setting: background_execution
Description:
Setting to 1 makes XX-Client run in the background, like a Windows service. Setting to 0 shows a console Window where input/output data can be monitored.
----------------------------------------------------------------------
[kickstart.bat]
This should only be necessary for XFactor receivers that have never used a dongle. This causes XX-Client to send a command to the receiver so it will start sending ECM requests, even after hard/soft boots.
Attached Files