PDA

View Full Version : Scrambled channels on new DT6



MIA_FTA
03-18-2016, 03:42 AM
Hi all. I was finally able to get some channels working by mimicking the sat and tp settings from my old JB box to my new DT6. I get some adult and most of the HD channels. However none of the PPV movie channels that are normally in the 500 channel range. I keep getting a "scrambled channel" error. Any ideas? Not sure if Route66 has an active sub to these or if im doing something wrong with the Sat settings. See below.

For my old JB I had the following:

110
Tuner: LNB1 (fixed)
LNB Freq: 11250
Diseqc 1.0: Port 2
Diseqc 1.1: Disabled
Legacy SW: Off
Legacy LNB: Ocs-Dp
22k: Off
Polarity: Auto

119
Tuner: LNB1 (fixed)
LNB Freq: 11250
Diseqc 1.0: Port 1
Diseqc 1.1: Disabled
Legacy SW: Off
Legacy LNB: Ocs-Dp
22k: Off
Polarity: Auto

129
Tuner: LNB1 (fixed)
LNB Freq: 11250
Diseqc 1.0: Port 3
Diseqc 1.1: Disabled
Legacy SW: Off
Legacy LNB: Ocs-Dp
22k: Off
Polarity: Auto

thunderstruck
03-18-2016, 04:55 AM
channels if saying Scrambled are prolly not working thru iks66 at this time
You would see a No Signal message if it was equipment related

MIA_FTA
03-19-2016, 05:22 AM
thanks for the help thunder. turns out I just had to wait a few mins and reboot the DT6. once it came back I went to free HD channel and it was good. checked the other HD channels and all were good. adult channels and movie channels came up as well in the AM. I am up and running on my new DT6 now. thanks to all that helped out.
channels if saying Scrambled are prolly not working thru iks66 at this time
You would see a No Signal message if it was equipment related